WiFi extender is somehow slower than the bad WiFi it was supposed to fix 

I put a WiFi extender upstairs because the back bedroom barely gets a usable signal from the router downstairs.

Problem is the extender is ridiculously slow. I’m getting like 4–8 Mbps through it while downstairs near the router I get around 300. Sometimes it’s a little better after rebooting it, then it goes right back to being awful.

The extender is plugged into an outlet in the hallway maybe 10 feet from the bedroom. I figured that was better than putting it inside the actual dead zone.

Is the extender just crap or am I setting this up wrong?

Before you blame the extender, unplug it and stand right next to that outlet with your phone.Connect directly to the main router and test from there. If the WiFi is already terrible at that spot, the extender has basically nothing good to repeat.

@Logic_Craft That actually might be the problem. The hallway signal looks okay on my phone though. Usually 2–3 bars.

Bars are pretty useless for this. Two bars can mean very different things depending on the phone. of making the client and mesh traffic fight over the same radio.

Yeah, measure the actual signal instead of moving the extender around randomly. Grab a WiFi analyzer — NetSpot or something similar — and check the signal from the main router at a few outlets between the router and that bedroom. You’re looking for a place where the original WiFi is still reasonably strong, not the place where you finally lose it. The extender needs a decent connection back to the router too.

@Prize-Marsupial-9 So basically I should be testing the location without the extender first?

Exactly. Test the source signal first. Otherwise you’re troubleshooting the repeater when the real problem might just be where you plugged it in.

Honestly I’d skip the extender and get mesh.

Ignore anyone telling you an extender always cuts your speed exactly in half. It depends on how the thing is designed and what radios/backhaul it’s using. But a cheap repeater using the same radio/channel to receive and retransmit traffic absolutely can eat a lot of airtime. Add a weak backhaul and retries and performance can get ugly fast. 4 Mbps ugly? Yeah, potentially.